Lesson 1 – Multi-Site Test
513
1-1 Overview
For a test method-based test suite, if you set up the Parallel Mode Enable
testflow flag and Allow Parallel testsuite flag, the test suite can be
executed for multiple sites. However, if a test method program is
developed as single-site test, the test method program is invoked site by
site (serial testing). To perform multi-site testing for the test method
program, some APIs must be added to the test method program. If so, a
specified block of the test method program can be invoked in parallel for
all the sites.
Serial Execution and Parallel Execution
The following shows the program flow of the test method program
optimized for parallel execution, and describes the behavior briefly.
To Next Page
Loading...
