Lesson 2 – Creating a Test Method
447
2-5 Registering a Test Method Shared
Library
Before you select a test method program in the Test Flow Editor,
the corresponding shared library must be registered to the system.
There are the following two types of the registration:
• DEV Type
This type shared library is registered for the application you
currently developed. Therefore, the shared library can be called
from the application only.
• SYS Type
This type shared library can be called from any applications on
the system.
This section describes how to register a test method shared library
as the DEV type. For the SYS Type, see “Test Method
Programming Reference” manual.
Registering a Shared Library as DEV Type
To register the test method shared library of the current project to
the system as the DEV type, select Register from the Build pull-
down menu of the Project window.
As default, when you build a shared library, the shared library is
always registered after building automatically.
NOTE If you create the project directory outside the device directory such
as <home_dir>/<project_dir>, select Register Method from
the Preference pull-down menu. Next, click on absolute path
then
OK
, before registration.
Unregistering a Shared Library from the System
To unregister the test method shared library of the current project
from the system, select Unregister from the Build pull-down
menu of the Project window.
To Next Page
Loading...
Need help?
General
