Lesson 6 – Executing the DAC Linearity Test
265
3 Enable REFRESH SELECTED DATA AUTOMATICALLY to always update
the displays of the Mixed-Signal Tool as soon as new test data is
available.
4 Enable AUTOSCALE WHILE UPLOAD. This ensures that uploaded
waveforms are completely visible on the display.
Now you can change the upload configuration parameters as
desired. For detailed information about these parameters refer to
the manual “Test Setup”, Chapter “Using the Mixed-Signal Tool”.
How to Upload Data
To upload data:
1 Click UPLOAD in the Upload Configuration window (this also saves
the present configuration)
– or –
close the Upload Configuration window by clicking D
ONE and click
U
PLOAD in the waveform result section of the Mixed-Signal Tool
panel
– or –
click O
VERLAY in the waveform result section of the Mixed-Signal
Tool panel.
NOTE UPLOAD replaces the previous data shown in the waveform result
section. O
VERLAY lets you keep the previous data and overlay up to 8
waveforms.
If an uploaded waveform is not displayed on the Mixed-Signal Tool
panel, you may need to change the panel view.
Keep in mind that you can archive all displayed waveforms.
To Next Page
Loading...
