Lesson 1 – Analog Modules
86
In digitizer mode or sampler mode, the single-ended signal or
differential signal can be captured from the pins shown in the
following table.
In addition to the single-ended/differential input routes, the DC
routes and loop-back routes are available in the WDD.
All routing is switched by the input multiplexer.
For other components in the digitizer (input amplifier, filter, ADC,
timing generator, sequencer, waveform memory, and SYNC_DATA
pin), see the description in “High Resolution / High Speed
Digitizer” on page 79.
Input
Possible Input Pin in Input Route of WDD
(for Digitizer Mode or Sampler Mode)
Single-ended input 1 input only of 8 inputs:
A+, B+, C+, D+, A-, B-, C-, or D-
Differential input 1 input only of 4 inputs:
A+&A- pair, B+&B- pair, C+&C- pair, or D+&D- pair
To Next Page
Loading...
Need help?
General
