5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-51
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
direct_connect_uri The URI to be inserted as the To
address of an INVITE sent in
response to the device going
off-hook. If this property is set,
an off-hook event triggers an
immediate INVITE with the value
of this property as the To
address. If this property is not
set, an off-hook event provides
the dial tone to the port,
allowing the user to dial a call in
the usual manner.
In XML this is a string of up to 99
characters and is an optional
parameter. In TL1 this is a string
of up to 32 characters. The
default value is a null string,
which indicates no direct
connect. Set the
enable_warmline parameter to
“yes” to use the
direct_connect_uri parameter.
YYAll Yes TL1 using
DIRCONNURIP
PROFID using
ent-profile-v
oipappservic
e
CLI using
dir-conn-prof
using
configure
voice ont
voip-app-serv
ice
message_event_uri The URI to which a subscription
for message-waiting events is
sent. If this property is not set,
the user agent shall not
subscribe for message waiting
events. This value is a URI The
default is no URI, which disables
subscribe. When the parameter
is set to URI, you can configure
the allow_unmatched_notify
parameter.
When the string autofill is used,
this keyword substitutes a new
message_event_uri value based
on the filled value, after any
derived value, of the
address_of_record parameter.
For other devices, the value is an
empty string and cannot be
changed.
All lines of I-240W-S ONT should
be configured the same.
NYPackage
A, B, H,
I-240W-
S ONT
only
Yes TL1 using
VOICEMAIL
using
ed-ontvoicep
ortsip
CLI using
voice-mail-pr
of us in g
configure
voice ont
voice-sip-por
t
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(9 of 30)
To Next Page
Loading...
