Configuring an Internal DHCP Server Configuration File Parameters and Syntax
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 22-18
38 tcp-keepalive-
interval
option tcp-
keepalive-
interval 10;
numeric N/A Specifies the amount of time, in
seconds, to wait before sending a
keep alive message on a TCP
connection. A value of 0 indicates
keep alive messages on connections
should not be generated unless
specifically requested to do so by an
application. Valid range from 0 to
2,147,483,647
39 tcp-keepalive-
garbage
option tcp-
keepalive-
garbage false;
boolean False Specifies if the TCP keep alive
messages should be sent with a
garbage octet for compatibility with
older implementations.
Select True to enable a garbage octet
to be sent.
Select False to prevent a garbage
octet being sent.
40 nis-domain
option nis-
domain
"abc.example.
com";
text Same as in
Subnet
Profile
Network Information Service (NIS)
support is provided on SunOS 4.1x,
Solaris 2.x and HP_UX10 only.
Specify the NIS domain name. The
domain is formatted as a character
string from the NVT ASCII character
set.
41 nis-servers
option nis-
servers
10.10.0.30;
ip_address_
list
Same as in
Subnet
Profile
Lists the IP addresses (in order of
preference) identifying the NIS
(Network Information Service)
servers available to the client
42 ntp-servers
option ntp-
servers
10.10.0.50
ip_address_
list
Same as in
Subnet
Profile
Lists the IP addresses (in order of
preference) indicating NTP (RFC
868) servers available to the client.
43 vendor-specific
option vendor-
specific
vspInfo;
hexadecima
l_text
N/A Used by clients and servers to
exchange vendor-specific
information. The value for this option
is defined in the hexadecimal
format. The definition of this
information is vendor specific. The
vendor is indicated in the vendor
class identifier option. Servers not
equipped to interpret the vendor
specific information sent by a client
must ignore the related data. Clients
that do not receive desired vendor-
specific information should attempt
to operate without the related data.
The clients must announce that they
are working in a degraded mode.
Option
Code
dhcpd.conf
Key-word
dhcpd.conf
example
Data type
Default
Value
Description
To Next Page
Loading...
