Configuring an Internal DHCP Server Configuration File Parameters and Syntax
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 22-17
30 mask-supplier
option mask-
supplier false;
boolean False True indicates that response to the
subnet mask request should use
Internet Control Message Protocol
(ICMP).
False indicates the subnet mask
should not respond using ICMP.
31 router-
discovery
option router-
discovery
false;
boolean False True allows router discovery to be
performed as defined in RFC 1256.
False indicates that router discovery
need not be performed.
32 router-
solicitation-
address
option router-
solicitation-
address
10.10.0.100;
ip_address N/A Specifies the IP address where router
solicitation requests should be
transmitted.
33 static-routes
option static-
routes
10.10.0.100
10.10.0.200;
ip_address_
pair_list
N/A Specifies the list of static routes that
the client should install in its routing
cache. If multiple routes to the same
destination are specified, they are
listed in descending order of priority.
The routes consist of a list of IP
address pairs. The first address is the
router for the destination. The default
route (0.0.0.0) is an illegal
destination for a static route.
34 "trailer-
encapsulation
option trailer-
encapsulation
false;
boolean False Select True to identify whether the
client should negotiate the use of
trailers (RFC 893) when using the
Address Resolution Protocol (ARP) .
Select False to prevent the use of
trailers.
35 arp-cache-
timeout
option arp-
cache-timeout
10;
numeric N/A Specifies the time-out in seconds for
ARP cache entries, from 0 to
2,147,483,647.
36 ieee802-3-
encapsulation
option ieee
802-3-
encapsulation
false;
boolean False Use this option to identify the use of
Ethernet Version 2 (RFC 894) or
IEEE 802.3 (RFC 1042)
encapsulation for Ethernet interface.
Select True to use RFC 1042
encapsulation.
Select False to use RFC 894
encapsulation.
37 default-tcp-ttl
option default-
tcp-ttl 1;
numeric N/A Defines the default time-to-live (in
seconds) to use when sending TCP
segments. Enter a value from 1 to
255.
Option
Code
dhcpd.conf
Key-word
dhcpd.conf
example
Data type
Default
Value
Description
To Next Page
Loading...
