Configuring an Internal DHCP Server Configuration File Parameters and Syntax
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 22-16
21 policy-filter
option
policy-filter
10.10.0.100
255.255.0.0;
ip_
address_
mask_list
N/A Specifies policy filters for nonlocal
source routing. The filters consist of
the IP address list and masks. This
data specifies destination and mask
pairs with which to filter incoming
source routes. The client should
discard any source-routed datagram
whose next hop address does not
match one of the filters.
22 max-dgram-
reassembly
option max-
dgram-
reassembly 576;
numeric N/A Specifies the maximum reassembly
size of the datagram. Enter a value
between 576 and 65,535.
23 default-ip-ttl
option default-
ip-ttl 1;
numeric N/A Specifies the default time-to-live (in
seconds) to use on outgoing
datagrams as an octet between 1 and
255.
24 path-mtu-
aging-timeout
option path-
mtu-aging-
timeout 10;
numeric N/A Specifies the maximum time to be
allotted for Path Maximum Transmit
Unit (MTU) values to be discovered.
The timeout is in seconds, from 0 to
2,147,483,647.
25 path-mtu-
plateau-table
option path-
mtu-plateau-
table 68;
numeric_list N/A Identifies a table of MTU sizes to use
when performing Path MTU
discovery as defined in RFC 1191.
The table is formatted as a list.
Minimum value is 68.
Maximum value is 65,535.
26 interface-mtu
option
interface-mtu
68;
numeric N/A Specifies the Maximum Transmit
Unit (MTU) to be used on the related
interface. MTU is the frame size in a
TCP/IP network. Valid range from
68 to 65,535.
27 all-subnets-
local
option all-
subnets-local
false;
boolean False True indicates that all subnets share
the same MTU as of the subnet to
which the client user is directly
connected
False indicates that some of the
subnets connected may have smaller
MTUs.
28 broadcast-
address
option
broadcast-
address
10.10.255.255
N/A Same as in
Subnet
Profile
Specifies the broadcast address used
on the client's subnet.
29 perform-mask-
discovery
option perform-
mask-discovery
false;
boolean False True indicates that the client should
perform subnet mask discovery.
False indicates that no mask
discovery must be performed.
Option
Code
dhcpd.conf
Key-word
dhcpd.conf
example
Data type
Default
Value
Description
To Next Page
Loading...
