Configuring Access Guardian Configuring Port-Based Network Access Control
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-43
To see the name of the template that is assigned to a port, use the show unp port config command. For
example:
-> show unp port 1/1/5 config
Port 1/1/5
Port-Type = BRIDGE,
Redirect Port Bounce = Disabled,
802.1x authentication = Enabled,
802.1x Pass Alternate Profile = -,
802.1x Bypass = Disabled,
802.1x failure-policy = default,
Mac-auth allow-eap = -,
Mac authentication = Enabled,
Mac Pass Alternate Profile = -,
Classification = Enabled,
Trust-tag = Enabled,
Default Profile = -,
Port Domain Num = 0,
AAA Profile = -,
Port Template = portTemplate-1,
Port Control Direction = Both,
Egress Flooding = Not Allowed,
Admin State = Enabled,
Dynamic Service = -,
PVLAN Port Type = -,
802.1x Parameters:
Tx-Period = 30,
Supp-Timeout = 30,
Max-req = 2
If there is no template assigned to a UNP port, the “Port Template” field is blank. For example:
-> show unp port 1/1/11 config
Port 1/1/11
Port-Type = Access,
802.1x authentication = Enabled,
802.1x Pass Alternate Profile = -,
802.1x Bypass = Disabled,
802.1x failure-policy = default,
Mac-auth allow-eap = -,
Mac authentication = Enabled,
Mac Pass Alternate Profile = -,
Classification = Enabled,
Trust-tag = Enabled,
Default Profile = -,
Port Domain Num = 0,
AAA Profile = -,
Port Template = -,
Admin State = Enabled,
Dynamic Service = spb,
PVLAN Port Type = -,
802.1x Parameters:
Tx-Period = 30,
Supp-Timeout = 30,
Max-req = 2
To Next Page
Loading...
