Configuring Access Guardian OmniAccess Stellar AP Integration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-73
4 Configure any switch port that will connect to a Stellar AP device as a UNP bridge port. For example:
-> unp port 1/1/12 port-type bridge
5 If necessary, enable the UNP AP mode for the switch (this mode is enabled by default). For example:
-> unp ap-mode enable
6 Enable MVRP for the switch to facilitate the propagation of the AP management VLAN and AP client
VLANs. For example:
-> mvrp enable
7 Optionally disable authentication on the UNP port if authentication of the AP device is not required.
For example:
-> no unp port 1/1/12 802.1x-authentication
-> no unp port 1/1/12 mac-authentication
8 Optionally configure the QoS policy list, authentication flag status, or mobile tag status for the
defaultWLANProfile (changing other parameter values for this profile is not supported). For example:
-> unp profile defaultWLANProfile qos-policy-list qlist1
-> unp profile defaultWLANProfile authentication-flag
-> unp profile defaultWLANProfile inactivity-interval 200
ERROR: defaultWLANProfile parameters cannot be modified. Mobile-Tag, Qos-policy-
list, Authentication are only allowed
9 Optionally configure the system name, system location, and port alias. The information from one or
more of these settings is used to derive the AP Location information that is transmitted by the switch to
the connected AP device.
-> system name BWIAPS01
-> system location BWI Airport Hotel
-> interfaces port 1/1/12 alias BWI-AP01
Verify the OmniSwitch Configuration
1 Use the show vlan command to display the VLAN created for AP management and other VLANs
created to carry AP client-tagged traffic. Note that “UNP-DYN-VLAN” identifies VLANs dynamically
created for AP client traffic. For example:
-> show vlan
vlan type admin oper ip mtu name
------+-------+-------+------+------+------+------------------
1 std Ena Ena Ena 1500 VLAN 1
11 std Ena Dis Dis 1500 VLAN 11-AP Client
200 std Ena Dis Ena 1500 AP Management VLAN
500 unpd Ena Dis Dis 1500 UNP-DYN-VLAN
501 unpd Ena Dis Dis 1500 UNP-DYN-VLAN
2 Use the show vlan members command to verify the port assignments for the AP management VLAN.
For example:
-> show vlan 200 members
port type status
----------+-----------+---------------
1/1/20 qtagged inactive
1/1/24 qtagged inactive
To Next Page
Loading...
