Alcatel-Lucent OmniSwitch 6860 Series

Configuring Access Guardian OmniAccess Stellar AP Integration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-74
3 Use the show unp profile map command to verify the AP management VLAN is mapped to the
“defaultWLANProfile”. For example:
-> show unp profile defaultWLANProfile map vlan
Profile Name Vlan-Id
--------------------------------+--------
defaultWLANProfile 200
4 Use the show unp profile command to verify the configurable defaultWLANProfile parameter values.
For example (the fields highlighted in green are the only configurable parameters for the profile):
-> show unp profile defaultWLANProfile
Profile Name: defaultWLANProfile
Qos Policy = -,
Location Policy = -,
Period Policy = -,
CP Profile = -,
Redirect State = Dis,
CP State = Dis,
Authen Flag = Dis,
Mobile Tag = Dis,
SAA Profile = -,
Ingress BW = -,
Egress BW = -,
Ingress Depth = -,
Egress Depth = -,
Inact Interval = 10
5 Use the show unp port command to make sure Stellar AP devices are connected to UNP bridge ports.
For example:
-> show unp port 1/1/12
Port Port Type 802.1x Mac Class. Default 802.1X MAC Trust-Tag
Domain Auth Auth Pass-Alt Pass-Alt
------+------+------+--------+--------+--------+----------+----------+---------+--------
1/1/12 0 Bridge Enabled Enabled Enabled - - - Enabled
6 Use the show unp global configuration command to verify that the UNP AP mode is enabled. For
example:
-> show unp global configuration
Dynamic Vlan Configuration = Disabled,
Dynamic Profile Configuration = Disabled,
Auth Server Down Profile1 = -,
Auth Server Down Profile2 = -,
Auth Server Down Profile3 = -,
Auth Server Down Timeout = 60,
Redirect Port Bounce = Enabled,
Redirect Pause Timer = -
Redirect http proxy-port = 8080
Redirect Server IP = -
Allowed IP = -
Force L3-Learning = Disabled
Force L3-Learning Port Bounce = Enabled
802.1x Pass Through Mode = Disabled
AP Mode = Enabled