EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6860 Series

Alcatel-Lucent OmniSwitch 6860 Series
1078 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring Access Guardian Bring Your Own Devices (BYOD) Overview
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-137
Quick Steps for Zero Configuration mDNS and SSDP
Zero configuration varies with respect to the type of modes (Tunnel (Aruba), Gateway, Tunnel Standard,
Responder Mode).
If the network consists of Aruba wireless controllers (Aruba mode), the following must be
configured on the edge switch:
1 Enable mDNS and SSDP functionality using the zeroconf mdns admin-state and zeroconf ssdp
admin-state command.
To enable mDNS relay on the switch, enter:
-> zeroconf mdns admin-state enable
To enable SSDP relay on the switch, enter:
-> zeroconf ssdp admin-state enable
2 Configure the mode of operation for the switch. For Aruba APs, the mode must be set to tunnel. To
configure the mode, use the zeroconf mode command. For example:
-> zeroconf mode tunnel
3 Configure the tunnel source IP address (Loopback0 IP interface) for the GRE tunnel. To configure the
Loopback0 IP interface, use the ip interface command. For example:
-> ip interface Loopback0 address 10.1.2.3
4 Configure the Aruba responder IP address. The responder IP address must be configured to tunnel the
mDNS or SSDP packets in the tunnel mode. To configure the responder IP address, use the zeroconf
responder-ip command. For example:
-> zeroconf responder-ip 10.0.1.5
If the network does not consist of any responder and uses a gateway, the following must be
configured on the edge switch:
1 Enable mDNS and SSDP functionality using the zeroconf mdns admin-state and zeroconf ssdp
admin-state command.
To enable mDNS relay on the switch, enter:
-> zeroconf mdns admin-state enable
To enable SSDP relay on the switch, enter:
-> zeroconf ssdp admin-state enable
Note. By default, the switch will be in tunnel mode (Aruba mode).
Note. Ensure reachability to the Loopback0 IP address. If the Loopback0 address is not configured, the
operational status of mDNS or SSDP will be down.
Note. If the responder IP address is not configured or not reachable, then the operational status of mDNS or
SSDP will be down.

Table of Contents

Related product manuals