3-36 PN: 10580-00321 Rev. M S331L UG
3-6 Measurement Setup Cable and Antenna Measurements
Pass/Fail Messages
When set to On, a Pass or Fail message is displayed. Fail is displayed
when the trace crosses or touches a limit line, as illustrated in
Figure 3-28. Note that Upper(U) or Lower (L) or both (U, L) are
displayed. To change the size and location of the Pass/Fail message, tap
the small circled arrow in the lower-right corner of the large format
message box. The circled arrow is in the upper-left corner when the
message is in small format.
Figure 3-28. Pass/Fail Message Turned On
To Next Page
Loading...
