ATEQ PRIMUS F Series - Page 119

Sheet #654u – I/O Configuration
Version 1.04a User guide ATEQ 6th series Page 2/4
Then by using the arrows,
select the hope mode among CYCLING,
CONTINUOUS or PROGRAM and validate
with the
key.
#761/%*#0)'+1
Ź AUX 1 : CONTINUOUS
AUX 2 : CYCLING
AUX 3 : CYCLING
AUX 4 : CYCLING
OUTPUT : STANDARD
Two output modes are available: STANDARD
mode and COMPACT mode.
STANDARD: this is default the I/O relay board
connector configuration.
COMPACT: outputs are available on the I/O
relay board connector for the results of two
chained cycles. Outputs 1 and 2 are reserved
for the first cycle, outputs 3 and 4 for the
second cycle, output 5 for the end of the
chained cycles.
For the outputs connecting, see the sheets
"Electrics connectors", 692/1 for the F610,
692/2 for the F620 and 692/7 for the F670.
10(+

#761/

%*#0)'+1
IN7 TEST : No
IN7 : Pr Select
IN8 : Pr Select
IN9 : Pr Select
Ź OUTPUT : STANDARD
Do the same for the others outputs codes.