ATEQ PRIMUS F Series - Custome Unit Check; Custom Unit Check + Custom Unit Learn

Sheet #604u – Units function
Version 1.04a User guide ATEQ 6th series Page 4/4
1.2. CUSTOM UNIT CHECK
This special cycle is used to verify calibration in custom unit mode (Please refer to the
explanation in the previous paragraph for more information). The Custom "unit check" cycle
measures whether the calibration has drifted beyond the limits set as a percentage. If these
have been exceeded, an alarm will be triggered and a "custom unit learn" cycle or an
instrument check will be required.
If the opposite is the case the "Pass" and "end of cycle" or "Fail" and "end of cycle" Fail level.
The cycle screen is displayed confirming the
special cycle selection. Press the
"START CYCLE"
key.

Unit check
Pr 001
LEAK TEST
At the end of the special cycle, the result must
be pass (OK).

600.0
mbar
OK
3.33
TRIAL
3.00
Pr 01
TRIAL
READY
1.3. CUSTOM UNIT CHECK +CUSTOM UNIT LEARN
This special cycle enables the checking of learning in the custom unit mode (Please refer to the
previous paragraphs for more information). The checking cycle measures the drift in relation to
the imposed percentage limits. If the limits are not exceeded, a Custom Unit learn cycle will be
carried out automatically to refresh the value learnt.
If the percentage limit is exceeded, the instrument will display a Custom Unit drift error.
The cycle screen is displayed confirming the
special cycle selection. Press the
"START CYCLE"
key.

Chk+Lrn
Pr 001
LEAK TEST
At the end of the special cycle, the result must
be pass (OK).

600.0
mbar
OK
3.33
TRIAL
3.00
Pr 01
TRIAL
READY