Sheet #608u – Pre-fill and fill types
Version 1.04a User guide ATEQ 6th series Page 2/4
1.3. BALLISTIC
This fill mode enables fluctuation in the air pressure (filling parts with a high level of
deformation) and in particular allows the Max Pre-Fill limit to be exceeded without the cycle
stopping and an error message being displayed.
Associated parameters to be set:
¾Set PreFILL
(Pre fill pressure instruction).
¾Pre-FILL (pre-fill time),
¾Pre-DUMP (pre-dump time).
1.4. F
ILL RAMP (ELECTRONIC REGULATOR ONLY)
This fill mode applies only to electronic regulators and will allow the part to be slowly filled to the
Pre-Fill pressure in a linear manner over the duration of the fill time.
¾Max PreFILL. (maximum pre-fill pressure limit),,
¾Set PreFILL (Pre fill pressure instruction).
¾PRE-FILL. (pre-fill time),
¾PRE-DUMP (pre-dump time).
1.5. P
RE-FILL REGULATOR
This function applies when two regulators are installed in the instrument allowing the choice of
which regulator is to be used for pre-fill (1 or 2).
To Next Page
Loading...
Need help?
General
