Sheet # 698f – Burst Test
Version 1.04a User guide ATEQ 6th series Page 2/4
1.1. BURST TEST PARAMETERS
1.2. COUPLING TIME
Coupling times A and B are the 1
st
timers of the cycle.
If there is no automatic connector, coupling time A is a part of the cycle.
If an instrument is fitted with an automatic connector, coupling time A delays the pressurization
of the test part by allowing the activation of a first cycle connector at the test start. Coupling time
B allows the activation of a second automatic connector.
1.2.1. Ramp
This parameter is the total time of the rise ramp. Total time to start from the pressure 0 to the
instruction pressure. The device will calculate the rise speed in regard of this time and the final
pressure.
1.2.2. Meas. Start (measurement start))
This parameter is the waiting time before the burst supervision. If it is set to 0, the supervision
begins at the start of the ramp.
1.2.3. Level time (T. LEVEL)
This parameter is the level time of each steps. This time can't be greatter than the step time
calculated by the total time and the steps number.
1.2.4. Dump Time (DUMP)
By default, the device has a dump time equal to zero. This time must be set with several tests.
1.2.5. Pressure unit (Press. UNIT)
The different units are: bar, mbar, PSI, Pa, kPa, MPa, Pts (points).
The "Pts" unit displays the values in points measured by the sensor during the test cycle.
1.2.6. Maximum fill
This function is used to set a maximum limit for the fill pressure. A warning is triggered if this
limit is exceeded.
1.2.7. Minimum fill
This function is used to set a minimum limit for the fill pressure. A warning is triggered if this
limit is not reached.
To Next Page
Loading...
Need help?
General
