ATEQ PRIMUS F Series - Cut Off Function

Sheet #686u – "Cut off" Fonction
Version 1.04a Guide d’utilisation ATEQ Série 6 Page 1/1
"CUT OFF" FUNCTION
1. PRESENTATION
With the CUT OFF function, all the measurements less than the configured percent will have the
value 0.
2. PROCEDURE
Check the function is not hidden.
Then press the
key, the cursor switch
to the right hand.
2T(70%6+105
Ź CUT OFF : No
More functions…
By using the arrows, select
"Yes" and validate with the
key.
2T(70%6+105
Ź CUT OFF : Yes
More functions…
Then adjust the “% CUT OFF” parameter that
all the measurements under this percent value
will be displayed 0.
2T

(70%6

%761((
Ź % CUT OFF : 10