Sheet #654u – I/O Configuration
Version 1.04a User guide ATEQ 6th series Page 3/4
2. INPUTS CONFIGURATION
This menu is used to give a special function to the inputs 7, 8 or 9 on the connector, of the
Inputs/Outputs16 programs relay board, see the sheets "Electrics connectors", 692/1 for the
F610, 692/2 for the F620 and 692/7 for the F670.
The various functions available on inputs are:
¾Program selection,
¾Synchro test.
The different existing special cycles which appear in regard of the validated functions,
examples:
¾Regulator adjust,
¾Infinite fill,
¾Piezo auto zero,
¾ATR learning cycle,
¾Volume compute,
¾Customer Unit Learning,
¾Check Customer Unit Learning,
¾Check test result,
¾Sealed Pass part learn,
¾Sealed Fail part learn.
As well as the special maintenance cycles if that function is validated:
¾Regulator 1 adjust,
¾Regulator 2 adjust,
¾Leak sensor check,
¾Valve Auto-test,
¾Sensor status.
These functions are all the special cycles available in the instrument.
6 additional inputs are available on the "Outputs codes" board. These inputs are the same as
the board shows above, only the program selection is not available.
To Next Page
Loading...
Need help?
General
