ATEQ PRIMUS F Series User Manual

Sheet # 695u – Pressure Unit
Version 1.04a User guide ATEQ 6th series Page 1/1
PRESSURE UNIT
This parameter set the default pressure unit for the newest created programs and for the
pneumatic configuration functions as "Dump level", "Permanent blow" etc...
1. PROCEDURE
From the "CONFIGURATION" menu, select
the "PNEUMATIC" menu and then press the
button
/#+0%10(+)74#6+10
LANGUAGE : English
Ź PNEUMATIC
AUTOMATISM
SECURITY
MISCELLANEOUS
By using the arrows, select
the Press UNIT menu and validate with the
key.
/#+0%10(+20'7/#6+
ELEC. REG: 10000 hPa
REGUL. CTRL. : AUTO
PERM. REG. : No
PIEZO AUTO AZ : No
AZ SHORT : No
Ź Press UNIT : bar
BLOW MODE : No
DUMP LEVEL : No
By using the arrows, select
the default pressure unit you want and
validate with the
key.
/#+0%10(+20'7/#6+
ELEC. REG: 10000 hPa
REGUL. CTRL. : AUTO
PERM. REG. : No
PIEZO AUTO AZ : No
AZ SHORT : No
Press UNIT : mbar Ż
BLOW MODE : No
DUMP LEVEL : No
Note: this unit can be modified in the parameters menu.

ATEQ PRIMUS F Series Specifications

General

Brand	ATEQ
Model	PRIMUS F Series
Category	Test Equipment
Language	English