Sheet #625u – No Negative
Version 1.04a User guide ATEQ 6th series Page 1/1
NO NEGATIVE
1. PRINCIPLE
The No Negative function the measurement display becomes zero when the result is negative.
This function is useful when negative measurement results shouldn’t be displayed to the user or
sent to the PLC.
2. CONFIGURATION
Activate the function or check if it checked.
Press the
key, the cursor slide to the
right hand.
2#4#/2T
(70%6+10
ŹNO NEGATIVE : No
More functions…
By using the arrows, select
"Yes" and validate with the
key.
The "No Negative" function, when validated,
displays the value 0 is the result is negative.
Example : if the measurement result is -014
Pa, then the display will be 000 Pa.
2#4#/2T(70%6+10
Ź NO NEGATIVE : Yes Ż
More functions…
To Next Page
Loading...
Need help?
General
