Sheet #608u – Pre-fill and fill types
Version 1.04a User guide ATEQ 6th series Page 3/4
2. FILL TYPE
This function provides a choice of these possible types of fill.
2.1. STANDARD (BY DEFAULT)
The default setting - during Fill time, the Fill valve opens allowing the regulator to supply air to
the part at the regulator’s set pressure.
Associated parameters to be set: Set FILL (fill pressure instruction).
2.2. INSTRUCTION (SET)
This mode allows a Mechanical regulator to fill the part to a value less than the regulator’s set
pressure. When the pressure sensor in the instrument reads the Set Fill value, the Fill-Valve is
closed and the test sequence continues.
Associated parameters to set: Set Fill (instruction/target value),
2.3. BALLISTIC
This fill mode enables fluctuation in the air pressure (filling parts with a high level of
deformation) and in particular allows the maximum fill limit to be exceeded without the cycle
stopping and an error message being displayed. However, once the test sequence enters the
stabilization phase, the test pressure must be within the limits defined by Max Fill and Min Fill.
Associated parameters to set: Set Fill (instruction/target value),
2.4. RAMP (ELECTRONIC REGULATOR ONLY)
The device carries on a linear fill.
FILL ADJUST
2.5. FILL ADJUST
This function appears only with a device with an electronic regulator built in.
In case of part hard to fill, this function allows automatically correct instruction to reach precisely
the programmed pressure target.
Associated parameters to set:
¾Set FILL (fi
ll pressure instruction).
¾TIME ADJ (extra time for correction).
3. FILL REGULATOR
This function provides a choice of which of two regulators to use
for the fill (1 or 2).
To Next Page
Loading...
Need help?
General
