AudioCodes Mediant 1000B - Page 1086

User's Manual 1086 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
to other than default, the PSTNAlertTimeout parameter value is
overridden.
Presence Publish IP Group
ID
[PresencePublishIPGroupId]
Assigns the IP Group (by ID) configured for the Skype for Business
Server (presence server). This is where the device sends SIP
PUBLISH messages to notify of changes in presence status of Skype
for Business users when making and receiving calls using third-party
endpoint devices.
For more information on integration with Microsoft presence, see
Microsoft Skype for Business Presence of Third-Party Endpoints on
page 306.
Enable MsPresence
message
[EnableMSPresence]
Enables the device to notify (using SIP PUBLISH messages) Skype
for Business Server (presence server) of changes in presence status
of Skype for Business users when making and receiving calls using
third-party endpoint devices.
 [0] Disable (default)
 [1] Enable
For more information on integration with Microsoft presence, see
Microsoft Skype for Business Presence of Third-Party Endpoints on
page 306.
RTP Only Mode
configure voip > sip-
definition settings > rtp-only-
mode
[RTPOnlyMode]
Enables the device to send and receive RTP packets to and from
remote endpoints without the need to establish a SIP session. The
remote IP address is determined according to the Tel-to-IP Routing
table (Prefix parameter). The port is the same port as the local RTP
port (configured by the BaseUDPPort parameter and the channel on
which the call is received).
 [0] Disable (default)
 [1] Transmit & Receive = Send and receive RTP packets.
 [2] Transmit Only= Send RTP packets only.
 [3] Receive Only= Receive RTP packets only.
Note:
 To activate the RTP Only feature without using ISDN / CAS
signaling, you must do the following:

Configure E1/T1 Transparent protocol type (set the
ProtocoType parameter to 5 or 6).

Enable the TDM-over-IP feature (set the EnableTDMoverIP
parameter to 1).
 To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_x parameter.
 If per trunk configuration (using the RTPOnlyModeForTrunk_ID
parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
[RTPOnlyModeForTrunk_x] Enables the RTP Only feature per trunk. The x in the parameter name
denotes the trunk number, where 0 is Trunk 1. For a description of the
parameter, see the RTPOnlyMode parameter.
Note: For using the global parameter (i.e., setting the RTP Only
feature for all trunks), set the parameter to -1 (default).