Version 7.2 1161 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Table 65-58: CAS Parameters
Parameter Description
CAS Transport Type
cas-transport-type
[CASTransportType]
Determines the ABCD signaling transport type over IP.
[0] CAS Events Only = (Default) Disable CAS relay.
[1] CAS RFC2833 Relay = Enable CAS relay mode using
RFC 2833.
The CAS relay mode can be used with the TDM tunneling feature
to enable tunneling over IP for both voice and CAS signaling
bearers.
[CASAddressingDelimiters] Enables the addition of delimiters to the received address or
received ANI digits string.
[0] = (default) Disable. The address and ANI strings remain
without delimiters.
[1] = Enable. Delimiters such as '*', '#', and 'ST' are added to
the received address or received ANI digits string.
configure voip > interface e1-t1 >
cas-delimiters-types
[CASDelimitersPaddingUsage]
Defines the digits string delimiter padding usage per trunk.
[0] = (Default) Default address string padding: '*XXX#' (where
XXX is the digit string that begins with '*' and ends with '#',
when using padding).
[1] = Special use of asterisks delimiters: '*XXX*YYY*' (where
XXX is the address, YYY is the source phone number, and '*'
is the only delimiter padding).
Note: For the parameter to take effect, a device reset is required.
CAS Table per Trunk
configure voip > interface e1-t1 >
cas-table-index
[CASTableIndex_x]
Defines the CAS protocol per trunk from a list of CAS protocols
defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1 to
use the E&M Winkstart CAS (E_M_WinkTable.dat) protocol, and
Trunks 2 and 3 to use the E&M Immediate Start CAS
(E_M_ImmediateTable.dat) protocol:
CASFileName_0 = 'E_M_WinkTable.dat'
CASFileName_1 = 'E_M_ImmediateTable.dat'
CASTableIndex_0 = 0
CASTableIndex_1 = 0
CASTableIndex_2 = 1
CASTableIndex_3 = 1
Note:
You can define CAS tables per B-
channel using the parameter
CASChannelIndex.
The x
in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Dial Plan
configure voip > interface e1-t1 >
cas-dial-plan-name
[CASTrunkDialPlanName_x]
Defines the CAS Dial Plan name per trunk.
The range is up to 11 characters.
For exam
ple, the below configures E1_MFCR2 trunk with a single
protocol (Trunk 5):
ProtocolType_5 = 7
CASFileName_0='R2_Korea_CP_ANI.dat'
CASTableIndex_5 = 0
DialPlanFileName = 'DialPlan_USA.dat'
CASTrunkDialPlanName_5 = 'AT_T'
To Next Page
Loading...
