AudioCodes Mediant 1000B - Page 1214

User's Manual 1214 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description

[1] Route calls after manipulation = Calls are routed after
the number manipulation rules are applied.
Note:
 The parameter is not applicable if outboun
d proxy routing is
used.
 For number manipulation, see ''Configuring
Source/Destination Number Manipulation'' on page 541.
 To configure Tel-to-IP routing rules, see ''Configuring Tel-
to-IP Routing Rules'' on page 511.
Tel-to-IP Routing table
Tel-to-IP Routing
configure voip > gateway routing
tel2ip-routing
[Prefix]
Defines Tel-to-IP routing rules for routing Tel-to-IP calls.
The format of the ini file table parameter is:
[PREFIX]
FORMAT PREFIX_Index = PREFIX_RouteName,
PREFIX_DestinationPrefix, PREFIX_DestAddress,
PREFIX_SourcePrefix, PREFIX_ProfileName,
PREFIX_MeteringCode, PREFIX_DestPort,
PREFIX_DestIPGroupName, PREFIX_TransportType,
PREFIX_SrcTrunkGroupID, PREFIX_DestSIPInterfaceName,
PREFIX_CostGroup, PREFIX_ForkingGroup,
PREFIX_CallSetupRulesSetId, PREFIX_ConnectivityStatus;
[\PREFIX]
For more information, see ''Configuring Tel-to-IP Routing
Rules'' on page 511.
IP-to-Tel Routing Table
IP-to-Tel Routing
configure voip > gateway routing
ip2tel-routing
[PSTNPrefix]
Defines the routing of IP-to-Tel routing rules.
The format of the ini file table parameter is as follows:
[PSTNPrefix]
FORMAT PstnPrefix_Index = PstnPrefix_RouteName,
PstnPrefix_DestPrefix, PstnPrefix_TrunkGroupId,
PstnPrefix_SourcePrefix, PstnPrefix_SourceAddress,
PstnPrefix_ProfileName, PstnPrefix_SrcIPGroupName,
PstnPrefix_DestHostPrefix, PstnPrefix_SrcHostPrefix,
PstnPrefix_SrcSIPInterfaceName, PstnPrefix_TrunkId,
PstnPrefix_CallSetupRulesSetId, PstnPrefix_DestType;
[\PSTNPrefix]
For more information, see ''Configuring IP-to-Tel Routing
Rules'' on page 520.
IP to Tel Routing Mode
configure voip > gateway routing
settings > ip2tel-rte-mode
[RouteModeIP2Tel]
Determines whether to route IP calls to the Trunk Group
before or after manipulation of the destination number
(configured in ''Configuring Source/Destination Number
Manipulation Rules'' on page 541).
 [0] Route calls before manipulation = (Default) Calls are
routed before the number manipulation rules are applied.
 [1] Route calls after manipulation = Calls are routed after
the number manipulation rules are applied.
IP Security
configure voip > sip-definition
settings > ip-security
Determines the device's policy on accepting or blocking SIP
(IP) calls (IP-to-Tel calls). This is useful in preventing
unwanted SIP calls, SIP messages, and/or VoIP spam.
 [0] Disable = (Default) The device accepts all SIP calls.