Version 7.2 1215 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
[1] Secure Incoming calls = The device accepts SIP calls
only from IP addresses that are configured in the Tel-to-IP
Routing table or Proxy Sets table, or IP addresses resolved
from DNS servers from FQDN values configured in the
Proxy Sets table. All other incoming calls are rejected.
[2] Secure All calls = The device accepts SIP calls only
from IP addresses (in dotted-decimal notation format) that
are defined in the Tel-to-IP Routing table or Proxy Sets
table, and rejects all other incoming calls. In addition, if an
FQDN is defined in the routing table or Proxy Sets table,
the call is allowed to be sent only if the resolved DNS IP
address appears in one of these tables; otherwise, the call
is rejected. Therefore, the difference between this option
and option [1] is that this option is concerned only about
numerical IP addresses that are defined in the tables.
Note: If the parameter is set to [0] or [1], when using Proxies
or Proxy Sets, it is unnecessary to configure the Proxy IP
addresses in the routing table. The device allows SIP calls
received from the Proxy IP addresses even if these addresses
are not configured in the routing table.
Filter Calls to IP
configure voip > sip-definition
settings > filter-calls-to-ip
[FilterCalls2IP]
Enables filtering of Tel-to-IP calls when a Proxy Set is used.
[0] Don't Filter = (Default) The device doesn't filter calls
when using a proxy.
[1] Filter = Filtering is enabled.
When the parameter is enabled and a proxy is used, the
device first checks the Tel-to-IP Routing table before making a
call through the proxy. If the number is not allowed (i.e.,
number isn't listed in the table or a call restriction routing rule
of IP address 0.0.0.0 is applied), the call is released.
Note: When no proxy is used, the parameter must be disabled
and filtering is according to the Tel-to-IP Routing table.
IP-to-Tel Tagging Destination Dial
Plan Index
configure voip > gateway routing
settings > ip2tel-tagging-dst
[IP2TelTaggingDestDialPlanIndex]
Defines the Dial Plan index in the Dial Plan file for called prefix
tags for representing called number prefixes in Inbound
Routing rules.
The valid values are 0 to 7, where 0 denotes PLAN1, 1
denotes PLAN2, and so on. The default is -1 (i.e., no dial plan
file used).
For more information on this feature, see Dial Plan Prefix Tags
for IP-to-Tel Routing on page 799.
Note: The parameter is applicable only to digital interfaces.
IP to Tel Tagging Source Dial Plan
Index
cconfigure voip > gateway routing
settings > ip-to-tel-tagging-src
[IP2TelTaggingSourceDialPlanIndex]
Defines the Dial Plan index in the Dial Plan file for calling
prefix tags for representing calling number prefixes in Inbound
Routing rules.
The valid values are 0 to 7, where 0 denotes PLAN1, 1
denotes PLAN2, and so on. The default is -1 (i.e., no dial plan
file used).
For
more information on this feature, see Dial Plan Prefix Tags
for IP-to-Tel Routing on page 799.
Note: The parameter is applicable only to digital interfaces.
etsi-diversion
Determines the method in which the Redirect Number is sent
To Next Page
Loading...
