AudioCodes Mediant 1000B - Page 606

User's Manual 606 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
2. Click New; the following dialog box appears:
Figure 27-14: Supplementary Services Table - Add Dialog Box
3. Configure a supplementary service according to the parameters described in the table
below.
4. Click Apply.
You can also register and un-register an endpoint configured in the table:
 To register or un-register an endpoint:
1. In the Trunk Group Settings table (see ''Configuring Trunk Group Settings'' on page
505), configure the registration method using the 'Registration Mode' parameter.
2. In the Supplementary Services table, select the required endpoint.
3. From the 'Action' drop-down list, select Register. To unregister the endpoint, select
Un-Register.
Table 27-6: Supplementary Services Table Parameter Description
Parameter Description
General
Index
[ISDNSuppServ_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Global Phone Number
phone-number
[ISDNSuppServ_PhoneNumber]
Defines a global telephone extension number for the endpoint.
The global number is used for the following functionalities:
 Endpoint registration
 IP-to-Tel routing
 Mapping between local and global (E.164) numbers between
Tel and IP sides respectively
Local Phone Number
local-phone-number
[ISDNSuppServ_LocalPhoneNu
Defines a local telephone extension number for the endpoint
(e.g., the PBX extension number). The local number is used for
the following functionalities: