AudioCodes Mediant 1000B - Page 712

User's Manual 712 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
• If the source tag name "Type" equals "PBX" (i.e., SIP message from an IP Group
belonging to one of the IP PBXs), then use the value of the "Port" tag name,
configured in the 'Tags' parameter of the classified IP Group, as the local UDP
port on the leg interfacing with the proxy server for messages sent to the proxy
server:
General
Index
2
Rule Set ID
1
Condition
srctags.Type=='PBX'
Action
Action Subject
message.outgoing.local-port
Action Type
Modify
Action Value
param.ipg.src.tags.Port
• If the source tag name "Type" equals "ITSP" (i.e., SIP message from the ITSP),
then use the value (port number) of the local port on which the incoming message
from the proxy server is received by the device, as the value of the destination
tag name "Port". In other words, the value could either be "6001", "6002", or
"6003". This value is then used by the IP-to-IP Routing table to determine to
which IP PBX to send the message. For example, if the destination tag value is
"6001", the device identifies the destination as "PBX-1":
General
Index
3
Rule Set ID
1
Condition
srctags.Type=='ITSP'
Action
Action Subject
dsttags.Port
Action Type
Modify
Action Value
message.incoming.local-port
4. Open the IP-to-IP Routing table (see Configuring SBC IP-to-IP Routing Rules on page
695), and then configure the following IP-to-IP Routing rules:
• Routes calls from the IP PBXs (identified by the source tag name-value
"Type=PBX") to the ITSP (identified as an IP Group):
General
Index
1
Name
PBX-to-ITSP
Match
Source Tag
Type=PBX
Action
Destination Type
IP Group
Destination IP Group
ITSP