AudioCodes Mediant 800 - Page 1030

CHAPTER53 System Status
Mediant 800 Gateway & E-SBC | User's Manual
Field Description
■ "SESSION": Call has been answered and is established.
■ "RELEASE": Call has been terminated (SIP 200 OK).
Fax State Currently, not in use.
Coder + PTime Coder and packetization time used for the call.
Call Type Type of call:
■ "Voice": Voice call
■ "Fax": Fax call
Call Establishment
Method
Mode of call:
■ "Normal": No early media during SIP session establishment (before
call accepted).
■ "EarlyMedia": Media sent (e.g., announcements) before call
accepted by called party.
DTMF Selected
Method for Tx/Rx
DTMF Transport method used for the call. For configuring the transport
method, see Configuring DTMF Transport Types.
Basic
Channel Identifier: Channel identifier number.
Status Status of port:
■ "Inactive": No call
■ "Active": Active call
Call ID See above.
Endpoint ID ID of endpoint:
■ "Not Available"
Call Duration Call duration (in seconds) from when call was established.
Call Type Type of call:
■ "Voice": Voice call
■ "Fax": Fax call
Call Destination IP address of called party.
Coder Coder type used for the call.
Last Current Dis-
connect Duration
Duration of the disconnect signal.
Note: The parameter is applicable only to analog interfaces.
Line Current Line current (in mA).
Note: The parameter is applicable only to analog interfaces.
Line Voltage Line voltage (in V).
Note: The parameter is applicable only to analog interfaces.
Hook Status of phone:
- 990 -