Automation Direct DURApulse GS4 - Page 124

Page 4–30
DURApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Chapter 4: AC Drive Parameters
Fault ParaMeters suMMary (P11.xx)
For detailed information about the P11.xx parameter group, please refer to page 4–206.
GS4 Parameters Summary – Fault Parameters (P11.xx)
Parameter Range
Run
1)
Read/
Write
Modbus
Address
Settings
Hex Dec
De-
fault
2)
User
1) ♦ in the Run-Read/Write column indicates that the parameter can be set during RUN mode.
R/W indicates “read/write.”
Read indicates “read-only.”
2) Parameters can be restored to their default values using P9.08.
P11.00
Fault Output
Option 1
0: No Error
1~65535: (refer to Fault bit code)
♦R/W 0B00 42817 0
P11.01
Fault Output
Option 2
♦R/W 0B01 42818 0
P11.02
Fault Output
Option 3
♦R/W 0B02 42819 0
P11.03
Fault Output
Option 4
♦R/W 0B03 42820 0
(table continued next page)