Automation Direct DURApulse GS4 - Page 135

Chapter 4: AC Drive Parameters
Page 4–41
DURApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Type Hex Addr Dec Addr
P1.03 Acceleration Time 2
♦R/W 0103 40260
Type Hex Addr Dec Addr
P1.04 Deceleration Time 2
♦R/W 0104 40261
Type Hex Addr Dec Addr
P1.05 Acceleration Time 3
♦R/W 0105 40262
Type Hex Addr Dec Addr
P1.06 Deceleration Time 3
♦R/W 0106 40263
Type Hex Addr Dec Addr
P1.07 Acceleration Time 4
♦R/W 0107 40264
Type Hex Addr Dec Addr
P1.08 Deceleration Time 4
♦R/W 0108 40265
P1.03
thru
P1.08
Range/Units (Format: 16-bit unsigned) Default
P1�15=0: 0�00~600�00 sec
P1�15=1: 0�0~6000�0 sec
10�00
Parameters P1.03, P1.05, and P1.07 allow additional Acceleration Time settings which operate the
same way as does Acceleration Time 1, P1.01 (page 4–40).
Parameters P1.04, P1.06, and P1.08 allow additional Deceleration Time settings which operate the
same way as does Deceleration Time 1, P1.02 (page 4–40).
See alSo P3.03~P3.16 MulTi-FuncTion inPuT TerMinal FuncTion SeTTingS 8 anD 9 (Page 4–66) To SelecT The
DiFFerenT acceleraTion anD DeceleraTion TiMeS.