Chapter 4: AC Drive Parameters
Page 4–179
DURApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Type Hex Addr Dec Addr
P8.08 Power On Counter
Read 0808 42057
Range/Units (Format: 16-bit unsigned) Default
0~65535
~
Records the number of power cycles.
Type Hex Addr Dec Addr
P8.09 Power On Day
Read 0809 42058
Range/Units (Format: 16-bit unsigned) Default
0~65535
~
Records the number of days the drive has been powered on.
Type Hex Addr Dec Addr
P8.10 Power On Minute
Read 080A 42059
Range/Units (Format: 16-bit unsigned) Default
0~1439
~
Records the number of minutes the drive has been powered on.
After this parameter reaches 1,439 minutes it will roll over to 0, and P8.09 will increment by 1 day.
Type Hex Addr Dec Addr
P8.11 Accumulative Motor Operation Time (minute)
Read 080B 42060
Range/Units (Format: 16-bit unsigned) Default
0~1439
~
Type Hex Addr Dec Addr
P8.12 Accumulative Motor Operation Time (day)
Read 080C 42061
Range/Units (Format: 16-bit unsigned) Default
0~65535
~
P8.11 and P8.12 record motor operation time. Both parameters can be cleared by setting to 00.
Operation time less than 60 seconds will not be recorded.
Type Hex Addr Dec Addr
P8.13 Keypad Communication Fault Treatment
R/W 080D 42062
Range/Units (Format: 16-bit binary) Default
0: Warn & Continue Operation
1: Warn & Ramp to Stop
2: Warn & Coast to Stop
3: No Warning & Continue Operation
2
This parameter sets the response to a keypad communication fault.
N OTE: Use this parameter with P8.14 to enable Keypad Loss Detection. This is especially useful when
the drive is being controlled from the keypad or from External Terminals (with Keypad Stop Enabled).
NOTE: P8.14 must be > 0 for this Parameter to enable Keypad Timeout (disconnected keypad).
Type Hex Addr Dec Addr
P8.14 Keypad Time Out
R/W 080E 42063
Range/Units (Format: 16-bit unsigned) Default
0�0~100�0 sec
1�0
This parameter sets the keypad time out. After the time-out period ends with no communications,
the keypad will display “Keypad time out” “CP10,” and the drive will respond according to the
setting of P8.13 (Keypad Communication Fault Treatment).
NOTE: If P8.13 = 3 (No Warning), the drive will not respond to a loss of keypad communication.
To Next Page
Loading...
Need help?
General
