Automation Direct DURApulse GS4 - Page 63

Chapter 2: Installation and Wiring
Page 2–25
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
main CirCuiT Crimp ConneCTor speCifiCaTions (ConTinued)
dimensions = mm
frame size C (gs4 model #s: 2020, 2025, 2030, 4025, 4030, 4040)
NOTE: Crimp connectors are NOT required on A, B, and C frame drives.
NOTE: Heat shrink should comply with UL (600V, YDPU2).
Power Terminal Wiring Connectors: Heat Shrink Tubing:
frame size d0 (gs4 model #s: 4050, 4060)
NOTE: Crimp connectors ARE required on D0, D, E, F, and G frame drives.
NOTE: Heat shrink should comply with UL (600V, YDPU2).
Power Terminal Wiring Connectors:
(except Ground Terminal Connectors)
Heat Shrink Tubing:
(non-ground power connectors)
+0
-2
8.2 Min.
Ring lug
WIRE
Heat Shrink Tube
13 Min.
GROUND Terminal Wiring Connectors ONLY:
Heat Shrink Tubing:
(ground terminal power connectors)
Ring lug
22 Max.
8.2 Min.
11 Max.
32 Max.
WIRE
Heat Shrink Tube
13 Min.