Automation Direct DURApulse GS4 - Page 64

Page 2–26
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Chapter 2: Installation and Wiring
main CirCuiT Crimp ConneCTor speCifiCaTions (ConTinued)
dimensions = mm
frame size d (gs4 model #s: 2040, 2050, 4075, 4100)
NOTE: Crimp connectors ARE required on D0, D, E, F, and G frame drives.
NOTE: ADC ring terminal part #s for GS4 A-frame drives:
V70RK004011, V70RK004012, V70RK004017, V70RK004018
NOTE: Heat shrink should comply with UL (600V, YDPU2).
Power Terminal Wiring Connectors: Heat Shrink Tubing:
frame size e (gs4 model #s: 2060, 2075, 2100, 4125, 4150)
NOTE: Crimp connectors ARE required on D0, D, E, F, and G frame drives.
NOTE: Heat shrink should comply with UL (600V, YDPU2).
Power Terminal Wiring Connectors:
(except Ground Terminal Connectors)
Heat Shrink Tubing:
31MAX.
8.2MIN.
26.5MAX.
70MAX.
16
+0
-4
GROUND Terminal Wiring Connectors ONLY:
8.2MIN.
65.0MAX.
17.0MAX.
28.0MAX.