x
Specifying LSP group selection by DI assignment 5-34
SP ramp unit 5-35
SP up ramp / down ramp 5-36
SP low/high limit 5-37
Enabling/disabling SP ramp by DI assignment 5-37
5 - 6 Step operation 5-38
Number of LSP groups 5-38
SP ramp type 5-39
SP ramp unit 5-40
STEP time unit 5-41
STEP PV start 5-42
STEP loop 5-43
Step operation: LSP, PID group No., ramp, soak time 5-44
Internal contacts: operation type 5-46
5 - 7 Digital Input (DI) / Internal Contacts 5-47
Operation type 5-48
Internal event No. assignment 5-50
Input bit functions 5-51
Input assignment 5-52
Input assignment polarity 5-53
Function result polarity 5-53
DI assignment by Smart Loader Package model SLP-C1F 5-54
5 - 8 Internal Events 5-55
Operation 5-56
Operation type 5-62
Direct/reverse, standby, and READY mode operation 5-63
Alarm OR, special OFF, delay time unit 5-64
Main setting, sub-setting,hysteresis 5-65
ON delay time, OFF delay time 5-66
5 - 9 Digital Output (DO) 5-68
MV1/MV2 processing 5-69
Operation type 5-71
Output assignment 5-72
Output assignment polarity 5-73
Function result polarity 5-74
Latch 5-74
DO assignment by Smart Loader Package model SLP-C1F 5-75
5 - 10 Application Examples 5-76
Applications using the assignment function 5-76
5 - 11 Continuous output 5-85
Output range 5-85
Output type 5-86
Output scaling low/high limit 5-87
MV scaling width 5-88
5 - 12 Current Transformer (CT) Input 5-89
CT operation type 5-90
CT output 5-90
CT measurement wait time 5-90
Number of CT turns / number of CT power wire loops 5-91
5 - 13 Display on the Console and Key Operation 5-93
Key operation mode 5-93
[MODE] key function 5-93
To Next Page
Loading...
