Brother BAS-311F-0 - Page 108

Programmer 107
Chapter 2 Programming with Help Function
Modifying the program of a multiple stitch
When modifying the stitch length or the number of lines for a multiple stitch, the previously
created curve program can be used.
The previously created programs are required for modifying programs of multiple stitch.
Programs of multiple stitch written to floppy disks cannot be modified.
1. Select
and press .
2. Press .
The work clamp moves. When the needle point is at the start point for a multiple stitch, stop it by
pressing
.
3. Press .
4. Select
and press .
5. Select and press .
6. Input the stitch length and the number of lines. Press .
Calculation is performed based on the input data. When a buzzer stops, the needle point moves to the
end point for a multiple stitch.