178 Programmer
Chapter 3 Programming with Command Function
3. Move the needle with to select the second point, then press .
4. Move the needle to the corner point and input .
5. Repeat steps 3 and 4 and move the needle to the end point. Input .
When the alarm sound is complete, the needle point moves to the end position.
Creating feed data
Command to be used
Specifying split (the separation point for different patterns in sewing)
after feed
Moving in parallel for the feed
Creating split data after basting
Creating basting data
1. Press .
2. Determine the feed point with
.
To Next Page
Loading...
