120 Programmer
Chapter 3 Programming with Command Function
Please read before programming
Pressing a designated combination of keys will issue a command to the programmer. These key
combinations are called 'command'. This chapter describes the method of programming with
command.
Panel description and usage
Cancels an image display.
Lights when the feed is set.
Deletes a part of the data.
Press this key to create a
line or a circle.
Press this key for
smoothing or editing.
Press this key to start
or end a program.
"Turning power OFF"
(Refer to page 11.)
Press this key to display the
data image being created.
Press these keys to
input numerical values.
Press this key to
cancel operation.
Press this key to input
an end code.
Press these keys to
advance steps.
Press this key to set the
needle position or use this
key as a part of a command.
Press these keys to move
the needle.
To Next Page
Loading...
Need help?
General
