156 Programmer
Chapter 3 Programming with Command Function
Deleting A
1. Press .
2. Input the number of stitches to be deleted and
press
.
The example is deleting 1 stitch. Press .
3. The needle point moves to 1.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
Moving the pattern in parallel 1
The program data is moved in parallel. The example in the
left is used for explanation of moving the pattern in parallel
when the first stitch is the sewing start position.
Calling data
1. Specify the program number on the operation
panel and press the read/write switch to read
the data.
To Next Page
Loading...
