Programmer 185
Chapter 3 Programming with Command Function
Copying a pattern rotated clockwise (counterclockwise)
Command to be used
Copying a pattern rotated clockwise
Copying a pattern rotated counterclockwise
This function is available only when the needle is at the home position.
Values of 1 - 359 degrees are available for input.
The copied data is linked to the original data with a split data.
1. Make sure that the needle is at the home position.
Press if the needle is not at the home position.
2. Determine the center point for rotation with .
3. Input or .
4. Input the angle in 3 digits and press .
To Next Page
Loading...
