164 Programmer
Chapter 3 Programming with Command Function
Creating a curve
Command to be used
Input the stitch length in .
Example Pitch Input
0.5mm 005
12.0mm 120
This command represents completing creation of a curve.
Increase the number of plotting points to create a smoother curve.
One to 99 points are available for plotting.
1. Select the start point with
and press .
2. Input the stitch length in 3 digits and press .
3. Move the needle with and press .
4. Input at the end position of the needle.
To Next Page
Loading...
Need help?
General
