Brother BAS-311F-0 - Moving the Pattern in Parallel 2

Programmer 157
Chapter 3 Programming with Command Function
Moving in parallel
1. Move the work clamp with . Press
when the needle point is at A of the pattern.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
Moving the pattern in parallel 2
The program data is moved in parallel. The example in the
left is used for explanation of moving the pattern in parallel
when the first stitch is the escape point.
Calling data
1. Specify the program number on the operation
panel and press the read/write switch to read
the data.
Moving
1. Press and press .
The needle point moves to point A.