190 Programmer
Chapter 3 Programming with Command Function
Copying to the Y axis
Command to be used
Copying data to the Y axis passing the current the current needle position
from the start point or the feed point (excluding the number of feed
boundaries to be ignored) to the current needle position
1. Move the needle to the desired position.
Refer to “Moving needle point” (page 123).
2. Input .
Copying in the reverse direction
Command to be used
Copying data in the reverse direction from the start point or the feed point
(excluding the number of feed boundaries to be ignored) to the current
needle position
1. Move the needle to the desired position.
Refer to “Moving needle point” (page 123).
2. Input .
To Next Page
Loading...
