216 Programmer
Chapter 5 Reading/Writing Data
Writing data to a floppy disk
Writes data from the programmer to a floppy disk.
If there is data for creation, data can be written by pressing by pressing the Read/Write button on
the operation panel.
Be sure to use a formatted 2HD floppy disk. The floppy disk accompanying this product is already
formatted.
This operation cannot be available in command mode.
1. Select
and press .
2. Select and press .
3. Input the number of program with a numeric key.
If there is data, appears.
If there is no data,
appears. If appears, the data is from BAS-300 or BAS-300A series.
To Next Page
Loading...
