Programmer 189
Chapter 3 Programming with Command Function
Copying symmetrically to a point
Command to be used
Copying data symmetrically to the current needle position from the start
point or the feed point (excluding the number of feed boundaries to be
ignored) to the current needle position
1. Move the needle to the desired position.
Refer to “Moving needle point” (page 123).
2. Input .
Copying to the X axis
Command to be used
Copying data to the X axis passing the current needle position from the
start point or the feed point (excluding the number of feed boundaries to be
ignored) to the current needle position
1. Move the needle to the desired position.
Refer to “Moving needle point” (page 123).
2. Input .
To Next Page
