106 Programmer
Chapter 2 Programming with Help Function
Creating a multiple stitch
1. Select and press .
2. Input the stitch length and the number of lines for a multiple stitch. Press .
3. Move the needle point with and press .
When the embroidering direction should be changed, provide a split by pressing twice.
Press
and move the needle point from the inside line to the outside line (reversely).
becomes
valid after input of a split.
When programming, be sure that the points and splits specified on the inside line are paired with those
on the outside line respectively.
4. When the needle point has reached the end point, press three times.
A buzzer sounds. Calculation is performed based on the input data. A buzzer stops on completion of
programming.
To Next Page
Loading...
Need help?
General
