Programmer 29
Chapter 2 Programming with Help Function
Lines
The pattern with lines is programmed.
The example in the left is used for explanation of
programming.
Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Select with and press .
3. Move the work clamp with
. Press
when the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
4. Select with and press .
5. Input the stitch length and press
.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
6. Move the work clamp with . Press
when the needle point is at point B of the
pattern.
7. Repeat step 6 and create the program to point
E.
8. When point E is programmed, press
twice.
To Next Page
Loading...
