Brother BAS-311F-0 - Creating a Circle

86 Programmer
Chapter 2 Programming with Help Function
3. Move the needle with and press .
4. Press twice at the sewing end position.
Creating a circle
The following five options are available for creating a circle.
Creating a circle by specifying 3 points on the circumference
Creating a circle of the specified diameter in the clockwise direction
Creating a circle of the specified diameter in the counterclockwise direction
Creating a circle of the specified radius in the clockwise direction
Creating a circle of the specified radius in the counterclockwise direction
1. Select and press . (The position where is pushed becomes the 1st point of the
circle.)
2. Select the method of creating a circle and press .
Remaining plot count
Distance from the previous point
in the direction of X or Y axis
Stitch length
Check that both values
are 0.00 mm.