128 Programmer
Chapter 3 Programming with Command Function
Ending program
1. Press .
Resizing input
Resizing input is used to program a detailed pattern stitch by
stitch. The example in the left is used for explanation on of
programming the pattern to the magnification of 5.
Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Press .
is the command for resizing input.
Input the magnification (02, 05, 10) in
.
3. Move the work clamp with . Press
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
4. Repeat step 3 and create the program to point
D.
Inputting the end code
1. Press at the last stitch and press
.
The work clamp returns to the start position.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
To Next Page
Loading...
