124 Programmer
Chapter 3 Programming with Command Function
Creating program
Creating a line. Input the stitch length in .
Creating a circle by specifying 3 points. Input the overlap stitch counts in .
Creating a circle in the clockwise direction by specifying the diameter. Input the
overlap stitch counts in .
Creating a circle in the counterclockwise direction by specifying the diameter. Input
the overlap stitch counts in
Creating a circle in the clockwise direction by specifying the radius. Input the
overlap stitch counts in .
Creating a circle in the counterclockwise direction by specifying the radius. Input
the overlap stitch counts in .
Creating an arc by specifying 3 points
Creating a semicircle in the clockwise direction
Creating a semicircle in the counterclockwise direction
Creating a curve. Input a stitch pitch in . Input to complete the
curve data.
Creating a double stitch in the reverse direction to the sewing path. Input the width
of double stitch in .
Creating an parallel stitch in the same direction to the sewing path. Input the width
of parallel stitch in
.
Creating an offset. Input the width for offset in
.
Starting a multiple stitch.
Creating a multiple stitch. Input the number of lines for a multiple stitch in
.
Creating a zigzag stitch. Input the width of zigzag in
, and input the pitch of
zigzag stitch by pressing .
Inputting data (×2)
Inputting data (×5)
Inputting data (×10)
Stopping the needle at the upper end by split
Stopping the needle at the lower end by split
Carrying out zigzag stitch on the right side to the sewing path